3 INSTALLATION
3.2.10 Allocation of the cable glands of the wall-mounted versions
Pass the cables through the cable glands by preferably respecting the following allocation
in order to ease the wiring:
Conductivity sensor
and Pt cable
Current output cable
Fig. 3.18
Allocation of the cable glands, wall-mounted versions
3.2.11 Electrical wiring, wall-mounted version, 12-30 VDC, without relay
Before wiring the device, please read § 3.2.1, 3.2.3 and 3.2.10 carefully.
Install the transmitter as described in § 3.1.3. Lift the cover after having unfastened the
screws. Pass the cables through the cable glands by preferably respecting the allocation
indicated in § 3.2.10 then connect the terminals the same way as a panel-mounted version
without relay acc. to § 3.2.8.
3.2.12 Electrical wiring, wall-mounted version, 12-30 VDC, with relays
Before wiring the device, please read § 3.2.1, 3.2.3 and 3.2.10 carefully.
Install the transmitter as described in § 3.1.3. Lift the cover after having unfastened the
screws. Pass the cables through the cable glands by preferably respecting the allocation
indicated in § 3.2.10 then connect the terminals the same way as a panel-mounted version
with relays acc. to § 3.2.9.
CONDUCTIVITY 8225
Relay cables
12-30 VDC or 115/230 VAC
power supply cable
E-30-