How To Use The Self Adaptation Sets; Wet" Measurements; Dry" Measurements - Burkert MKEN-1094 Instructions De Service

5

HOW TO USE THE SELF ADAPTATION SETS

5.1

"Wet" Measurements

The gas meter has to be connected between simulation tank and suction pipe
to make "wet" measurements or an adaptation of a manually adjustable
system. Due to this the displaced vapor is sucked through the gas meter into
the storage tank.
It is important to connect the gas meter in the right direction. An arrow on the
gas meter signs the operating direction.
Figure 10: Connection of the gas meter during "wet" measurements
5.2

"Dry" Measurements

The gas meter has to be connected before the suction pipe to make "dry"
measurements or an automatic self adaptation. Due to this air is sucked
through the gas meter into the storage tank.
It is important to connect the gas meter in the right direction. An arrow on the
gas meter signs the operating direction.
Figure 11: Connection of the gas meter during "dry" measurements
52 MKEN-1094 Version A and C