Span-Compensation; Display Of Non-Compensated Conductivity; Conductivity Simulation - Burkert 8225 Notice D'utilisation

4 OPERATION

4.4.2 Span-Compensation

Within this mode, the user can change the basic setting of 20 mA. The procedure is
identical to the Offset-compensation. The transmitter generates 20 mA, if the Enter key is
pressed when "OFFSET" is displayed. If the displayed value is incorrect, it can be corrected
by entering the measured value.
SPAN
ENTER
CONDUCT.
ENTER

4.4.3 Display of non-compensated Conductivity

To display the non-compensated conductivity is displayed, press the ENTER key to change
the display.
CONDUCT. ENTER
COND SIM
ENTER
4.4.4 Conductivity-Simulation
The conductivity can be simulated within this menu allowing the user to test the system in
"dry condition". The simulated value influences the current output and the relays. The units
and decimal points selected in the submenu "UNIT" are actived.
COND SIM ENTER
END
ENTER
The simulation will remain active until the user enters another sub-menu.
SP= 20.00
0......9
SP= 19.96
Enter the measured value
8.34 mS.
The point behind the unit indicates thediffe-
rence between the display in this option and
the normal function mode.
00.00 mS
Enter the conductivity value
0......9
05.42 mS
E-41-
CONDUCTIVITY 8225