10.2 Maintenance Intervals - probst SH-2500-UNI-B Instructions D'emploi

Operating Instructions
SH 2500-UNI-B

10.2 Maintenance intervals

Inspect safety features
•
Vacuum gauge
•
Check that warning light flashes at correct
underpressure/overpressure values
•
Visual inspection of load securing chain 1)
Inspect vacuum filter and replace if necessary
Gasoline motor (see also separate operating instructions)
Inspect V-belt, replace if necessary
Replace V-belt
Check oil fill level (oil dipstick)
Change oil
Inspect air filter
Replace air filter (more frequently in dusty
environments)
Inspect spark plug
Replace spark plug
Vacuum pump (see also separate operating instructions)
Replace the oil and oil filter every 500 to 2000
operating hours and at least every 6 months (oil
quantity 1.5 l, oil type: see separate operating and
maintenance instructions for the vacuum pump)
Are the vacuum hoses in good condition (not brittle, not
kinked, no worn sections and no leaks)?
Are all connections (hose clamps, etc.) tight?
Are type, load capacity and warning signs in a complete and
legible condition?
Are the operating and maintenance instructions available
and are operators familiar with them?
Check all load-bearing parts (e.g. suspension) for
deformation, wear or other damage.
Clean suction plate / Inspect for cracks,
evenness of sealing lip, etc. Replace if necessary
Has the test label been updated?
General condition of the device
Leak test
Draining the condensation water
Condition of load securing chain 1)
1)
Once the load has been held by the load securing chain, the load securing chain must be properly tested and replaced
if necessary. Damaged load-securing chains must not be used any further!!
28 / 32
The yearly inspection must be performed by a qualified specialist.
:
(see chapter Sicherheit)
Maintenance and care
Daily
X
X
X
V7
Interval
Weekly Monthly Every
six months
X
X
X
X
X
X
Yearly
X
X
X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X
X
X
GB