Installation; Mechanical Connection; Initiation; Mounting The Suction Pad To The Lifting Device - probst SH-2500-UNI-B Instructions D'emploi

Operating Instructions
SH 2500-UNI-B
Pos: 17 /05 Installati on/KÜ_ Installation @ 0\m od15 _2.doc @ 5467 @ 1
7

Installation

Pos: 18 / 05 Installation/ 01 Mecha nischer Anbau/ Ü_M echa nischer A nbau @ 0\mod105_2.doc @ 7347 @
7.1

Mechanical connection

Pos: 19 / 99 geräte spez. Module /PG2 Vakuum -Verl ege syst eme/S H UNI 2500 b/Installation SH uni 2500 b @ 0\m od174_2.doc @ 81 87 @ 222
7.2

Initiation

The device must be installed and maintained by qualified personnel, mechanics and electricians.
7.3

Mounting the suction pad to the lifting device

●
Suspend the lifting device from the suspension eye bolt on the crane or hoist used. Secure it safely!
Take the weight of the lifting device and the maximum carrying capacity into consideration!
●
Insert the suction pad into the support of the lifting device.
●
Feed the socket pin into the boring until the projection of the socket pin is at the shoulder of the suction
pad. Turn the socket pin downward until the projection is secure under the support. Check whether the
socket pin firmly secured. The socket pin must not be able to be pulled out without turning.
●
Connect the vacuum hose to the suction pad and lock it with the integrated lock nut.
●
Before lifting loads check the safety equipment as described in section 1.12.
18 / 32
Installation
Suction pad
Projection
V7
Support
Lifting device
Socket pin
GB