Maintenance And Care; Maintenance; Mechanical - probst EXG-MAXI Instructions D'emploi

Pince de manutention pour plaques
Masquer les pouces Voir aussi pour EXG-MAXI:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance and care

7 Maintenance and care
7.1

Maintenance

To ensure the correct function, safety and service life of the device the following points must be executed in the
maintenance interval.
Used only original spare parts, otherwise the warranty expires.
All operations may only be made in closed state of the device!
For all operations you have to make sure, that the device will not close unintended. Danger of injury!!!
7.2

Mechanical

SERVICE INTERVAL
First inspection after
25 operating hours
All 50 operating hours
Minimum 1x per year
(at rough conditions shorten the
interval)
Maintenance work
Control and tighten all screws and connections.
(The implementation is only allowed by an expert).
Tighten all screws and connections (take care that the tightening torques according
to the property class of the screws are observed).
Check all existing safety elements (such as linchpins) for perfect function and replace
defective safety elements.
Check all joints, bolts, guidance's and gears for correct function, if necessary adjust or
replace it.
Check all Grippers (if available) for signs of wear.
Grease all slidings (if available) when the device is in opened position with a spatula.
Grease all grease nipples (if available) with a grease gun.
Check of all the suspension parts, bolts and straps. Check for corrosion and safety by
an expert.
15 / 18

Publicité

Table des Matières
loading

Table des Matières