Programming Mode (The Grey Values Blink) - Burkert 8623 Instructions De Service

8.2

Programming mode (the grey values blink)

Set the multiplier of K
Factor 1
Selecting the default set-
value
Setting up all the following parameters
Setting the multiplier or
the unit, if present
Fig. 16 Programming mode
Setting the figures before
the decimal point for K
Factor 1
Setting the figures before
the decimal point for the
corresponding parameter
Return to standard mode
Setting the figures after the
decimal point for K Factor 1
Setting the figures after
the decimal point for the
corresponding parameter
8623 - 25