Setting In The Programming Mode - Burkert 8623 Instructions De Service

7.3.1 Setting in the Programming mode

Internal set-value (C.01)
Set up Change
set-value set-value
Fig. 10: Setting the parameters
NOTE
Set up
K Factor 1
Set up
Selection
External set-value (C.02)
Set lower
limit
Set upper
limit
Set KP
Set TN
Return to Standard mode
The lower 7 bars indicate which parameter is being set up (see
front of folded page).
Change
K Factor
1
Change
Selection
Ratio control (C.03)
Change
Set
lower
K factor 2
limit
Change
Set ratio
upper
limit
Change
KP
Change
TN
Change
K factor
2
Change
Change
ratio
ratio
8623 - 13