Troubleshooting The Copilot; For Further Troubleshooting And Repair; Frequently Asked Questions; Authorized Service Centers - MINN KOTA RIPTIDE POWERDRIVE Manuel Du Propriétaire

TROUBLESHOOTING THE COPILOT

TROUBLESHOOTING THE COPILOT
Cause
Remote is not transmitting.
When receiver is powered up, it sounds a
beep pattern (1 long beep, 2 short beeps,
pause, repeat).
The prop is not turning but the Prop ON
audio pattern is still going.

FOR FURTHER TROUBLESHOOTING AND REPAIR

We offer several options to help you troubleshoot and/or repair your product. Please read through the options listed below.
Buy Parts Online
You can buy parts on-line directly from our website at minnkotamotors.com. Orders confirmed by 12 noon central time will ship
same day if in stock. Orders after 12 noon central time will ship the next business day if in stock.

Frequently Asked Questions

We have FAQs available on our website to help answer all of your Minn Kota questions. Visit
"Frequently Asked Questions" to find an answer to your question.
Call Us (for U.S. and Canada)
Our consumer service representatives are available Monday – Friday between 7:00 a.m. – 4:30 p.m. CST at 800-227-6433. If you
are calling to order parts, please have the 11-character serial number from your product, specific part numbers, and credit card
information available. This will help expedite your call and allow us to provide you with the best consumer service possible. You can
reference the parts list located in your manual to identify the specific part numbers.
Email Us
You can email our consumer service department with questions regarding your Minn Kota products.
To email your question, visit

Authorized Service Centers

Minn Kota has over 800 authorized service centers in the United States and Canada where you
can purchase parts or get your products repaired. Please visit our Authorized Service Center page
on our website to locate a service center in your area.
34 | minnkotamotors.com
Effect
The battery is discharged.
Receiver may not have "learned" the remote.
With the foot pedal (if applicable) connected, the MOM-
CON switch is in the CON position. An audio response will
be heard if a button is pressed with the foot pedal in the
CON position.
If remote has been taken apart, the keypad and top case
may have been installed backwards.
The foot pedal (if applicable) Momentary/Constant Switch
is in the CON position.
Prop Speed is set at "0".
The Prop ON audio pattern occurs only in Audio Mode 3
minnkotamotors.com and click on "Support".
Solution
Replace battery.
Remote needs to be learned. See the Adding/Removing Remotes
section of this manual to learn the remote.
The foot pedal (if applicable) switch must be placed in Momentary
Mode (MOM). The receiver will not accept any commands from the
remote with the switch in the Constant Mode (CON) position.
Take remote apart. See the Replacing the Battery section of this
manual and reinstall case halves with the proper orientation.
The foot pedal (if applicable) switch must be placed in the MOM
position. The beeping sound will continue until the switch is placed in
the MOM position.
Increase the Prop Speed above "0"
Switch Audio Mode to either Audio 1 or 2. See the Audio Modes section
of this manual.
minnkotamotors.com
©2021 Johnson Outdoors Marine Electronics, Inc.
and click on
Scan to visit Minn
Kota service online.