MINN KOTA COPILOT Manuel Du Propriétaire page 8

INSTALLATION
4
ITEM(S) NEEDED
#1 x 2
e. Turn the Right Sideplate over and position the
CoPilot Receiver (Item #2) on the inside of the
Right Sideplate so that the receiver mounting
holes are aligned with the Sideplate Mounting
Holes. Position the wires so that they pass to the
right of the CoPilot Receiver. This should consists
of a Foot Pedal Connection, a Power Connection
and an Antenna wire.
f. Using the two #8 x 5/8'' screws (Item #1)
provided, insert the screws through the receiver
and into the Right Sideplate. Be sure that the
wires are not pinched in the Sideplate Mounting
Holes when tightening the two screws. Do not
over tighten.
5
g. With the Right Sideplate laying flat, and the
CoPilot receiver that was just installed facing
upwards, route the yellow wire antenna around
the pegs protruding from the Right Sideplate
along the right and bottom edge of the CoPilot
Receiver. Follow the grooves in each of the pegs.
h. Deploy the motor.
i. On the mount, lift the Center Housing to access
the components below. The Center Housing can
be released by depressing the tabs on each side
that keep it latched to the Base Extrusion.
8 | minnkotamotors.com
#2 x 1
4e
Sideplate
Mounting Holes
Screws
CoPilot Receiver
Power Connection
4f
CoPilot Receiver
5g
CoPilot Receiver
Antenna
Power Connection
5i
Center Housing
Left
Sideplate
Motor Cable Plug
Power Cable
Right Sideplate
Foot Pedal
Connection
Foot Pedal
Right Sideplate
Connection
Antenna
Power Connection
Right Sideplate
Foot Pedal
Connection
Right Sideplate
Base
Extrusion
Power
Connection
Foot Pedal
Connection
©2016 Johnson Outdoors Marine Electronics, Inc.