MINN KOTA COPILOT Manuel Du Propriétaire page 9

6
j. Once lifted, using a #3 Screwdriver, remove the
single screw holding the Strain Relief Bracket in
place.
k. Release the Power Cable and Motor Cable Plug
from the Strain Relief Bracket.
l. Connect the Motor Cable Plug that was
previously connected to the Foot Pedal to the
CoPilot receiver Power Connection that has the
female receptacles.
m. The Foot Pedal Connection from the CoPilot
receiver can be connected to the Foot Pedal once
the installation is complete.
n. Place the Power Cable and the Foot Pedal
Connection from the CoPilot Receiver on the
Base Extrusion so that it can be captured in the
Strain Relief Bracket.
7
o. Using a #3 Screwdriver, replace the screw that
was holding the Strain Relief Bracket in place.
p. Be sure that the wires are routed in a way that
they can not be pinched and reseat the Center
Housing in place.
NOTE: The wires should pass under the
Center Housing over the Base Extrusion in the
notch that creates a separation from the base
and the housing. The connection between the
Motor Cable Plug and the Power Connection
should be under the Center Housing when it is
seated.
©2016 Johnson Outdoors Marine Electronics, Inc.
6j
Screw
Strain Relief Bracket
Motor Cable Plug
Power Cable
6l
Base Extrusion
Foot Pedal
Connection
Power Cable
7o
Strain Relief Bracket
7p
Center
Housing
Foot Pedal
Connection
Power
Cable
INSTALLATION
Power
Connection
Foot Pedal
Connection
Power
Connection
Motor Cable Plug
Screw
Base Extrusion
Power
Connection
minnkotamotors.com | 9