Using The Copilot; Audio Modes - MINN KOTA RIPTIDE SP Manuel De L'utilisateur

USING THE COPILOT

AUDIO MODES

There are three receiver audio modes available. The unit is factory set to Audio Mode 2. To switch from one audio mode to
another, simultaneously press and hold the increase and decrease speed buttons for one second. The receiver will respond with
1, 2 or 3 audible beeps indicating the corresponding receiver audio mode change.
• Audio Mode 1 = All of the normal audible sounds mentioned in this owners manual, but no audible beeps for
speed increase / decrease or prop on / off .
• Audio Mode 2 = Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off .
• Audio Mode 3 = Same as audio mode 2 plus the prop on audible click every few seconds.
NOTE: When the corded foot pedal is in control and the propeller is on, the prop on indicator click will be heard if the receiver is
set to audio mode 3.
AUDIO PATTERN
1 Beep
1 Beep
2 Beeps
Single tick every 1.5 seconds When the prop is active including when speed is set to 0.
1 Beep
2 Beeps
3 Beeps
1 Chirp
2 Second long beep
5 Beeps
Steady tone
4 Beeps
Ten second warbling sound
that transitions into a steady
tone
1 Long beep, 2 short beeps,
pause (repeat)
14 | minnkotamotors.com
WHAT CONDITION
Pressing the INCREASE SPEED or DECREASE SPEED
button.
Pressing the PROP ON/OFF button to turn the prop on.
Pressing the PROP ON/OFF button to turn the prop off .
Switching to audio mode 1 (pressing the INCREASE SPEED
and DECREASE SPEED simultaneously for 1 second).
Switching to audio mode 2 (pressing the INCREASE SPEED
and DECREASE SPEED simultaneously for 1 second).
Switching to audio mode 1 (pressing the INCREASE SPEED
and DECREASE SPEED simultaneously for 1 second).
Every time the receiver is powered up and there is at least one
remote ID learned.
Every time the receiver is powered up and there are no remote
IDs learned.
Foot pedal speed control is moved after speed has been
adjusted with remote.
Heard while holding down the learn button on the receiver.
After a remote button is pressed while the receiver learns its
ID.
Heard during the process used to clear all stored remote IDs.
After the learn switch is released, a 2 second long beep will be
heard.
Powered up with MOM/CON in the CON (or MOM switch
held) when foot pedal is moved to momentary, the power up
audio will be heard.
US IT OCCURS IN WHICH AUDIO MODE
Modes 2 and 3
Modes 2 and 3
Modes 2 and 3
Mode 3
All
All
All
All
All
All
All
All
All
All
©2015 Johnson Outdoors Marine Electronics, Inc.