Audio Modes - MINN KOTA COPILOT Manuel Du Propriétaire

COPILOT
• As soon as any remote button is pressed, the initial speed setting will be set to approximately the same value as the Speed
Control value on the Foot Pedal. The prop will not automatically turn on until the Prop ON/OFF button on the remote is
pressed.
• Pressing the Momentary Button on the Foot Pedal or adjusting the Speed Control dial will override the remote and receiver
function. Control of the motor will automatically go to the Foot Pedal. The prop speed will also revert to the current value of
the Speed Control dial on the Foot Pedal.
Operating without the Foot Pedal
• If the foot pedal is not being used, the CoPilot receiver will always react to any commands from the CoPilot remote.

AUDIO MODES

There are three receiver Audio Modes available. The unit is factory set to Audio Mode 2. To switch from one audio mode to
another, simultaneously press and hold the increase and decrease speed buttons for one second. The receiver will respond with
1, 2 or 3 audible beeps indicating the corresponding receiver audio mode change.
Audio Mode Function
All of the normal audible sounds mentioned in this owners manual, but no audible beeps for speed increase/
Mode 1
decrease or prop on/off.
Mode 2 Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off.
Mode 3 Same as audio mode 2 plus the prop on audible tick every 1.5 seconds.
NOTE: When the Foot Pedal is operating the motor and the propeller is on, the prop on indicator tick will be heard if the
receiver is set to Audio Mode 3.
Audio Pattern
1 Beep
1 Beep
2 Beeps
Single tick every 1.5 seconds
1 Beep
2 Beeps
3 Beeps
1 Chirp
2 second long Beep
5 Beeps
Steady Tone
4 Beeps
Ten second warbling sound that
transitions into a steady tone
1 long Beep, 2 short Beeps, pause
(repeat)
12 | minnkotamotors.com
What Condition Causes Audio Pattern
Pressing the Increase Speed or Decrease Speed button
Pressing the Prop ON/OFF button to turn the Prop on
Pressing the Prop ON/OFF button to turn the Prop off
When the Prop is active including when Speed Control dial is set to 0
Switching to audio Mode 1
Switching to audio Mode 2
Switching to audio Mode 3
Every time the receiver is powered up and there is at least one remote learned
Every time the receiver is powered up and there are no remote learned
Speed Control dial on Foot Pedal is moved after speed has been adjusted with remote
Heard while holding down the Learn button on the receiver
Heard after a remote button is pressed while the receiver learns it.
Heard during the process used to clear all stored remote after the learn switch is released,
a 2 second long beep will be heard
Powered up with Momentary/Constant Switch in the CON position (or the Momentary
Button held) when the Foot Pedal is moved to momentary, the power up audio will be
heard
Audio Mode
Modes 2 and 3
Modes 2 and 3
Modes 2 and 3
Mode 3
All
All
All
All
All
All
All
All
All
All
©2016 Johnson Outdoors Marine Electronics, Inc.