Keyboard - Schenck Process DISOMAT Opus Instructions De Service

English

2.3.2 Keyboard

A) 'DISOMAT Opus'
In the DISOMAT keyboard, there are three blocks of keys, i.e. 'input block', 'control
block' and 'operating block' (from left to right):
•
The input block keys serve i.a. for input of figures, letters (capital and lower-
case) and signs.
•
The control block keys are used for data input, navigation in menu tree and
as function keys.
•
The operating block keys are used to operate the scale.
The tables below reflect all possible keys, or key combinations. It may be that a
certain key or key combination is defined only in the one or other operating state.
Input Block Key Functions
Key Function
[SHIFT]:
Use of this key is indicated in this documentation by the symbol :
[SHIFT] + ['Key'].
Character input: The character set that can be keyed is distributed over 2
levels. Please keep the [SHIFT] button pressed to key in characters of the
second level. Also refer to the manual BV-H2313, section on 'Entering
Characters via the Input Block'.
Calling up functions: Each button of the control block is assigned a second
function. Please also keep the [SHIFT] button pressed before pressing the
desired button.
[<Alphanumerical characters>]:
If the operator requests inputs (such as strings), numbers(0...9), upper-case
letters (A...Z), lower-case letters (a...z) and special characters(such as
commas or space) can be keyed in with these buttons also using the [SHIFT]
button.
BV-H2322 AA 0630
- 40 -
®
DISOMAT Opus – Operating Instructions
© Schenck Process GmbH, Darmstadt
General Control