Schenck Process DISOMAT Opus Instructions De Service page 38

English
Personnel
Preparation, installation, commissioning, operation, maintenance, and servicing may
exclusively be performed by skilled persons only.
All persons working on the measuring system are required to observe the safety hints
and know the parts of the technical documentation relevant to their work.
The supervisor is responsible for instructing his operators to observe all regulations
and instructions given.
Parameter Changes
The measuring system's functionality is determined by parameters, which must
exclusively be changed by persons familiar with the measuring system operating
principles (e.g. after training by SCHENCK). Parameters incorrectly set may cause
injuries or damage to the machine whenever a user control system is connected. They
can also adversely affect weighing operation.
Password
Software parameters are protected from unintended change by password. The
measuring system user has to ensure safe password handling.
Error Message Acknowledgement
Error messages may be acknowledged only after cause of fault has been remedied.
Before you acknowledge an error message, check to see that connected peripherals
properly operate. Check to see that connected control systems, if any, are in fail-safe
state.
Maintenance and Repair
•
During maintenance and repair, observe any warning symbols on the scale.
•
Before performing work on the mechanical system or peripherals (particularly
the control system), disconnect the measuring system and protect the system
from inadvertent restart.
•
Before performing work on the electrical equipment, disconnect the power
supply.
•
The devices may be operated only in the provided housings. There is danger
of contacting live parts.
Moisture Protection
Protect all system parts, electrical items in particular, from moisture (e.g. during
maintenance and servicing) when housings are open. Observe housing protection
standards.
Modification & Replacement
Unauthorized modifications to the system and/or use of replacement parts not
supplied by SCHENCK voids SCHENCK's liability for any resulting damages. This
particularly applies to modifications, which have the potential to affect the operating
safety of the measuring system.
Replacement of Components
Spare parts must meet the technical specifications indicated by SCHENCK. To ensure
this requirement is met, only genuine SCHENCK spare parts should be used. When
using other spare parts, the warranty will be void.
BV-H2322 AA 0630
- 34 -
®
DISOMAT Opus – Operating Instructions
© Schenck Process GmbH, Darmstadt
Safety Instructions