RockShox Boxxer 2000 Mode D'emploi page 2

Features
Features
• 178 mm of positive travel
• 12 mm of negative travel
• Open bath hydraulic damping system
• Aluminum top cap with internal preload adjustment
• External rebound damping adjustment (right fork leg)
• External low speed compression damping adjustment (left fork leg)
• Internal high speed compression damping adjustment (left fork leg)
• 32mm diameter hard-anodized Easton upper tubes
• One-piece magnesium lower tube assembly
• 20 mm thru-axle dropouts
• Disc brake ready
• Removable V-Brake™ mounting system
S
TANDARD
• Yellow (2) Medium springs (20 in-lbs.) - Preinstalled
• Different weight RockShox Oils
• (10) Preload spacers (4 preinstalled in each leg and 6 more packaged with the fork)
• Owner's Manual
Steerer Tube
Upper Crown
Lower Crown
Upper Tube
Brake Tab
N : F
OTE ORK SHOWN ABOVE MAY NOT FULLY RESEMBLE YOUR FORK
Page 2
E
QUIPMENT
Top Cap
One Piece
Lower Tube Assembly
Disk Brake Mount
Through-axle Shaft Hole
.
PN 950-004836-00, Rev. A
Consumer Safety Information
Riding a bike is dangerous. Not properly maintaining or inspecting your bike is even more dangerous. It's also
dangerous not to read these instructions.
1. Before riding the bicycle, be sure the brakes are properly installed and adjusted. If the brakes don't work
properly, the rider could suffer serious and/or fatal injuries.
2. Forks with hangerless braces are only designed for 'V'-type or hydraulic cantilever brakes. Do not use any
cantilever brake other than those intended by the brake manufacturer to work with a hangerless brace. Do
not route the front brake cable and/or cable housing through the stem or any other mounts or cable stops.
Do not use a front brake cable leverage device mounted to the brace. Only mount disc brakes through the
mounting holes provided on the lower tube. Do not use disc brakes or other devices that mount to other
locations on the lower tube besides the mounts provided. The lower tubes were not designed to sustain the
stresses such brakes or other devices could place on them, and structural failure to the fork may result, which
may result in loss of control of the bicycle with possible serious and/or fatal injuries.
3. Use extreme caution not to tilt the bicycle to either side when mounting the bicycle to a carrier by the fork
drop-outs (front wheel removed). The fork legs may suffer structural damage if the bicycle is tilted while the
drop-outs are in the carrier. Make sure the fork is securely fastened down with a quick release. Make sure the
rear wheel is fastened down when using ANY bike carrier that secures the fork's drop-outs. Not securing the
rear wheel can allow the bike's mass to side-load the drop-outs, causing them to break or crack. If the bicycle
tilts or falls out of its carrier, do not ride the bicycle until the fork is properly examined for possible damage.
Return the fork to your dealer for inspection or call RockShox if there is any question of possible damage
(See International Distributor List in the rear of this manual). A fork leg or drop-out failure could result in
loss of control of the bicycle with possible serious and/or fatal injuries.
4. If the fork ever loses oil or if it makes sounds of excessive topping out, stop riding the bicycle immediately
and have the fork inspected by a dealer or call RockShox. Continuing to ride with the fork in either of these
conditions could result in loss of control of the bicycle with possible serious and/or fatal injuries.
5. Always use genuine RockShox parts. Use of aftermarket replacement parts voids the warranty and could cause
structural failure to the fork. Structural failure could result in loss of control of the bicycle with possible
serious and/or fatal injuries.
Important: RockShox forks are designed for competitive off-road riding and do not come with
the proper reflectors for on-road use. Your dealer should install proper reflectors to meet the
Consumer Product Safety Commission's (CPSC) Requirements for Bicycle Standards if the fork
is going to be used on public roads at any time.
PN 950-004836-00, Rev. A
English
Page 3