CAMPAGNOLO BORA ULTRA 80 Manuel Pour L'utilisateur page 18

- Insert the adapter into the small tubes B (Fig. 1.4) and screw it thoroughly by using
exclusively the provided wrench C (Fig. 1.5).
B
1.4
- Insert the valve A into the adapter (Fig. 1.6) and screw it strongly by using exclusi-
vely the provided wrench C (Fig. 1.7).
A
1.6
- Proceed with inflation of the tubular (follow the instructions on paragraph 2.2).
- To deflate the tubular, unscrew the valve and press it against the mechanism inside
the adapter.
C
1.5
C
1.7
2.2 - INFLATING AND DEFLATING THE TIRE
• To inflate the tire: remove the cap, unscrew the valve and inflate using a pump with a
pressure gauge to obtain the required pressure, then tighten the valve and re-fit the cap.
• To deflate the tire: remove the cap, slightly unscrew the valve, then press it until the
required pressure is obtained; tighten the valve and re-fit the cap.
CAUTION!
Never exceed the maximum inflation pressure recommended by the tire
manufacturer.
Excessive tire pressure reduces the grip of the tire on the road and increa-
ses the risk that the tire will unexpectedly burst.
Inflation pressure that is too low reduces tire performance and increases
the probability of sudden and unexpected loss of tire pressure. In addition,
premature wear and damage to the rim may occur.
Note
The tire pressure should also be adjusted depending on the weight of the rider; a
heavy rider should have a greater tire pressure than a light rider.
WARNING!
Incorrect tire pressure could cause tire failure or loss of control of the
bicycle, resulting in an accident, personal injury or death.
5