• Red/green lights (D) flashes indicate that the battery pack will not charge
and must be replaced.
3.
Portable Battery Pack: From "sleep mode", the battery will wake up in
approximately ten (10) seconds.
Portable Battery Pack: A completely discharged battery pack will fully charge in
4.
approximately one (1) hour. The battery pack will stay fully charged if left on the
charger.
5.
Portable Battery Pack: When the green light indicates that the battery pack is
fully charged, remove the battery pack from the charger.
6.
Integrated Battery Pack: Connect the charger plug (G, Figure 9) to the engine.
7.
Integrated Battery Pack: A completely discharged battery pack will fully charge in
approximately four (4) hours.
8.
Integrated Battery Pack: When the green light indicates that the battery pack is
fully charged, remove from the charger.
9.
To check available charge, push the Battery Fuel Gauge button (E, Figure 6 7).
10.
When not in use, disconnect the battery charger from the electrical outlet.
Battery Fuel Gauge
To check available charge, push the Battery Fuel Gauge button (E, Figure 6 7). The
display lights (H) will indicate the approximate amount of available charge remaining in
the battery pack.
Display Lights
Four lights
Three lights
Two lights
One light
Light flashes
Integrated Battery Pack: When connected to the charger, if all display lights are off
then the battery is fully charged. Disconnect the charger.
Start and Stop Engine
See Figure: 10, 11, 12, 13
Start Engine
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
When Starting Engine
• Make sure that spark plug, muffler, fuel cap and air cleaner (if equipped) are in
place and secured.
• Do not crank engine with spark plug removed.
• If engine floods, set choke (if equipped) to OPEN or RUN position, move throttle (if
equipped) to FAST position and crank until engine starts.
WARNING
Improper use of battery and charger can result in an electrical shock or fire.
When Operating
• Keep battery charger dry. Avoid exposing battery pack to rain or wet conditions.
• To reduce the risk of electrical shock, do not allow water to flow into AC plug.
• Do not short circuit; never place any object into the battery contacts.
WARNING
POISONOUS GAS HAZARD. Engine exhaust contains carbon monoxide, a
poisonous gas that could kill you in minutes. You CANNOT see it, smell it, or
taste it. Even if you do not smell exhaust fumes, you could still be exposed to
carbon monoxide gas. If you start to feel sick, dizzy, or weak while using this
product, shut it off and get to fresh air RIGHT AWAY. See a doctor. You may
have carbon monoxide poisoning.
• Operate this product ONLY outside far away from windows, doors and vents to
reduce the risk of carbon monoxide gas from accumulating and potentially being
drawn towards occupied spaces.
Available Charge
75% to 100%
50% to 75%
25% to 50%
10% to 25%
Low
• Install battery-operated carbon monoxide alarms or plug-in carbon monoxide
alarms with battery back-up according to the manufacturer's instructions. Smoke
alarms cannot detect carbon monoxide gas.
• DO NOT run this product inside homes, garages, basements, crawlspaces,
sheds, or other partially-enclosed spaces even if using fans or opening doors and
windows for ventilation. Carbon monoxide can quickly build up in these spaces
and can linger for hours, even after this product has shut off.
• ALWAYS place this product downwind and point the engine exhaust away from
occupied spaces.
NOTICE
This engine was shipped from Briggs & Stratton without oil. Before you
start the engine, make sure you add oil according to the instructions in this manual.
If you start the engine without oil, it will be damaged beyond repair and will not be
covered under warranty.
Note: Equipment may have remote controls. See the equipment manual for location and
operation of remote controls.
1.
Check the engine oil. See the Check Oil Level section.
2.
Models with portable battery pack: Mount the battery pack (A, Figure 10) in
the engine battery tray on top of the engine. Make sure battery pack is securely
installed. Battery pack may represent equipment key in some instances.
Note: Models with portable battery pack: To wake up a new battery, a First
Time quick charge of approximately ten (10) seconds is required. See the When To
Charge Battery Pack section.
3.
Make sure equipment drive controls, if equipped, are disengaged.
4.
Move the fuel shut-off (D, Figure 11), if equipped, to the OPEN position.
5.
Move the throttle control (B, Figure 11), if equipped, to the FAST position. Operate
the engine in the FAST position.
6.
Models with electric start switch: Hold the engine stop lever (C, Figure 12)
against the handle. Move the electric start switch to the START position. See the
equipment manual for the location and operation of the electric start switch.
7.
Models without electric start switch: Hold the engine stop lever (C, Figure 12)
against the handle. Engine will automatically start. See the equipment manual for
operation of the engine stop lever.
NOTICE
To extend the life of the starter, use short starting cycles (five seconds
maximum). Wait one minute between starting cycles.
Models with portable battery pack: If the engine will not crank and the battery pack
display lights are flashing, then the battery pack temperature is too hot or current draw is
too high. All four battery display lights (H, Figure 13) will flash a warning for 10 seconds.
The battery pack does not have a fuse, but will automatically reset after 10 seconds. If
battery pack temperature is too hot (over 140 F, 60 C), remove the battery and allow it
to cool. To avoid excess current draw on lawnmowers, keep the mower housing clean of
grass build-up and debris.
Note: If the engine does not start after repeated attempts, contact a local dealer or go
to BRIGGSandSTRATTON.com or call 1-800-233-3723 (in USA).
Stop Engine
1.
Engine Stop Lever: Release the engine stop lever (E, Figure 12).
Throttle Control, if equipped with stop feature: Move the throttle control (B,
Figure 11) to the STOP position.
Electric Start Switch, if equipped: Move the electric start switch to the OFF /
STOP position. See the equipment manual for the location and operation of the
switch. Remove the key and keep in a safe place out of the reach of children.
2.
After the engine stops, move the fuel shut-off (D, Figure 11), if equipped, to the
CLOSED position.
3.
Models with portable battery pack: Remove the battery pack. The battery pack
may represent equipment key in some instances.
Maintenance
NOTICE
If the engine is tipped during maintenance, the fuel tank, if mounted on
engine, must be empty and the spark plug side must be up. If the fuel tank is not
empty and if the engine is tipped in any other direction, it may be difficult to start due
to oil or gasoline contaminating the air filter and/or the spark plug.
WARNING
When performing maintenance that requires the unit to be tipped, the fuel tank, if
mounted on the engine, must be empty or fuel can leak out and result in a fire or
explosion.
We recommend that you see any Briggs & Stratton Authorized Dealer for all
maintenance and service of the engine and engine parts.
9