Installation; Installation Onto The Pipe; Installation Of The Fitting Onto The Pipe - Burkert 8025 Manuel D'utilisation

Warning
risk of injury due to non-conforming installation.
• The fluid installation can only be carried out by qualified and
skilled staff with the appropriate tools.
• Respect the assembly instructions for the fitting used.
risk of injury due to unintentional switch on of power supply
or uncontrolled restarting of the installation.
• Take appropriate measures to avoid unintentional activation of
the installation.
• Ensure that the restart of the installation is controlled after any
interventions.
protect this device against electromagnetic interfe-
rence, ultraviolet rays and, when installed outdoors, the
effects of the climatic conditions.
7.2.

installation onto the pipe

danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive fluids.
12
English
Type 8025/8035 battery powered

Installation

The 8025 flowmeter-totalizer has to be inserted into an S020 fitting
mounted on a pipe.
The SE35 electronic module has to be inserted into an S030 fitting-
sensor mounted on a pipe.
7.2.1. installation of the fitting onto the
pipe
→
Choose an S020 or S030 fitting appropriate to the velocity of
the fluid inside the pipe: refer to the graphs at right.
→
Install the fitting on the pipe as described in the operating
instructions of the fitting used.