Operating Levels Of The Device - Burkert 8025 Manuel D'utilisation

8.3.

operating levels of the device

The device has two operating levels: the Process level and the Con-
figuration level.
The Process level makes it possible:
• to read the flow rate measured by the device and the value of the
totalizers, the main and the daily one.
• to reset the daily totalizer.
• to access the Configuration level.
The Configuration level makes it possible to set the device
parameters.
Table 4: Default settings of the device
Function
LANGUAGE
UNIT of the flow rate
UNIT of the totalizers
Number of decimals
K FACTOR
FILTER
16
Default value
English
l/s
litre
2
46,60
Filter 2
English
Type 8025/8035 battery powered
Operatingandcommissioning
Process level
12.6 l/s
87654 l
231 l.
+
0......9
> 2 s
To reset the daily
totalizer (identified by
a dot after the volume
units).
Possible if the ENTER key is unlocked (see chap. 8.2)
2)
Fig. 12: Diagram of the levels of the device
Once the settings of a parameter is done if you do not want
to adjust another parameter, go to the "END" parameter of
the Configuation level and press
and go back to the Process level.
Configuration level
lANGUAGE
UNit
+
ENTER
K-FACtOR
2)
> 5 s
FiltER
tOtAl
Process level
ENTER
to save the settings
END