List Of Error Messages - Tecno-gaz Europa B xp 24 Mode D'emploi

DXLA408 Rev_11

5.2.- List of Error Messages

ERROR CAUSE
E 200 Low water level
E 250 Low level water cleaned up with loading
from deionizer
E 300 Maximum level used water
E 401 Door open
E 451 Door unlocked
E 461 High temperature in chamber for
Vacuum test (above 40°)
A 250 Cycle begins without water
A 001 Interrupted cycle
A 011 Irregular pc display
A 101 Vacuum not reached in 10min.
A 111 Vacuum not maintained for first phase VT
A 121 Vacuum not maintained for second phase VT Reset and repeat the cycle
A 401 Hatch opened during the cycle or problem closing To control the closing system
A 501 Pressure not maintained
A 551 Irregular 1° temperature sensor
A 552 Irregular 2° temperature sensor
A 641 Overly high pressure
A 651 Overly high temperature
A 661 Irregular temperature comparison
A 701 Working pressare not reached
A 751 Low temperature
A 761 Irregular pressure sensor
A 801 Irregular unloading pressure
A 901 Main voltage too low
SUBSTUTUTE RESIN CLEN WATER resin finished
D The printer's door is not closed
P Paper is missing
L There is low voltege on the line
REMEDY
Fill tank
Fill tank
Empty tank
Close door with attention
Open door and close again
Shut off and wait 10 minutes
Control Waterclean device
Reset and restart cycle
Shut off and restart autoclave
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Reset and repeat the cycle
Inform electric energy provider
Follow the instruction in Paragraph 14.2 of
the manual
Try to close the printer's door
Insert paper
To try to connect the machine to the net
electrical worker in an other point; if the
problem persists to contact a electrician
- 39 -