Installation; Installation Of Unit-Mounted Master Flux - Tecno-gaz Master Flux Plus Mode D'emploi

ENGLISH
06
Remove the packaging and check the conditions of the equipment.
Do not use equipment that presents evident damage due to transportation.
6.1

Installation of unit-mounted master flux

Screw the 3 steel spacers (3) onto the flowmeter box (2).
Remove the protections from the flowmeter box supply nipples.
Install the flowmeter box on the unit by inserting the steel spacers (3) into the relative holes
on the unit, securing them to the unit using 3 plastic spacers (5), 3 washers (6) and the three
thumb nuts (7) supplied.
Position the plastic cover near the three holes on the unit.
Attach the plastic cover by screwing on the three thumb screws (4) supplied.
If you are using the exhaled gas exhaust tube (Figure 9 art SMFA197), screw the supplied
nozzles onto the plastic fittings (Figura 3 Pos 8/9).
20
25 24
21A
10

INSTALLATION

FLOWMETER BOX INSTALLATION (Figure 3)
FRONT COVER INSTALLATION (Figura 3 Pos 1)
EXHAUST NOZZLE INSTALLATION
19
18
21 25 24
21A
26
M
N
22 25
21A
27
P L
16 17
24 23
28
Figure 5