Display View In The Operating Level With An Active Pulse Memory; Configuration / Oval Gear Meter; Configuration / Metering Controller - Ecolab Elados EDPL V60 Notice Technique

10.4.11.2 Display view in the operating level with an active pulse memory

Display view in operation

10.4.12 Configuration / Oval gear meter

The oval gear meter function makes it possible to record a "real" value in the Operating
data/Litres menu option (see chapter
Furthermore, this menu option must be enabled to use the metering controller function
(see chapter
only)").
The oval gear meter menu option can only be enabled if the pump is upgraded to the
V60
In order to activate the dongle board in connection with the oval wheel meter, the mains
NOTE
voltage must be isolated and restored. (Unplug power plug or switch the pump off and
back on again!) The oval gear meter function is automatically activated when an OGM
is connected.
10.4.12.1 Selection

10.4.13 Configuration / Metering controller

Fig. 10.35
If an OGM Plus is connected, when the metering controller function is activated, the metering
quantity measured by the OGM is compared with a pre-defined target metering quantity. If
there is a discrepancy between the values, the metering frequency of the pump is
automatically increased or decreased.
Since metering frequency can only be adjusted within the performance limitations of the
pump, setting the metering rates higher than 80 or 90% of the maximum possible metering
frequency is not recommended. This will ensure that the metering controller retains sufficient
reserves to react to negative control deviations.
The metering controller function can only be enabled if the pump is upgraded to the
V60
NOTE connected.
In order to activate the dongle board in connection with the oval wheel meter, the pump
must be switched off and then on again.
417102214_EDPL_V60.docx
Pos.
1
Fig. 10.33
(V60
10.4.13 "Configuration / Metering controller
PLUS
by a dongle board and an oval gear meter (see Accessories) has been connected.
PLUS
by a dongle board and an oval gear meter OGM
Description
Pulse memory enabled (flashing icon = stored pulses are
currently being processed)
PLUS
& OGM or OGM
10.6.3 "Operating data / Litres").
(V60
Fig. 10.34
-

The oval gear meter is active
PLUS
(V60 & OGM or OGM
96
PLUS
only)
PLUS
& OGM or OGM
The oval gear meter is inactive.
(Default setting)
PLUS
only)
PLUS
(see Accessories) has been
Rev. 1.12.11
PLUS
PLUS