Sentiotec Pro D Serie Instructions D'installation Et D'utilisation page 123

Instructions for use for the user
Intensity regulation when the dimmer switch function is activated
When the dimmer switch function for the additional output is activated, the power
for the additional device can be set to a scale of 1 to 7. 7 corresponds to full power.
1. Select the additional output symbol 7 by pressing the mode button D.
Then briefly press the On/Off button A.
► The additional appliance switches on.
► The display 1 shows the intensity.
2. Set the desired power of the additional output with the plus button B and
the minus button C.
► The display 1 shows the set intensity.
Intensity regulation when the dimmer switch function is deactivated
When the dimmer switch function for the additional output has been deactivated,
you can only switch the additional appliance on and off. The appliance will always
operate at full power.
1. Select the additional output symbol 7 by pressing the mode button D.
Then briefly press the On/Off button A.
► The additional appliance switches on.
► The display 1 shows "on".
Room temperature control with the additional output
If the additional output mode is set to room temperature regulation (see: "Set-
ting mode of the additional output (only Pro D2i/Pro D3i)" on page 44),
a cubicle temperature can be set that is regulated via the additional output. This
can be used to regulate the sauna room temperature using only infra-red lamps
or infra-red heater panels.
Setting options
● Infra-red lamps (without foil sensor): 30 - 70 °C
● Infra-red heater panels (with foil sensor): 30 - 50 °C
If the sauna heater is already active or if it is started additionally, tem-
perature regulation of the additional output is not possible. The mode is
automatically changed to intensity regulation and the additional output
continues operating at the highest level.
WORLD OF WELLNESS
p. 53/70
EN