Sentiotec Pro D Serie Instructions D'installation Et D'utilisation page 111

Installation instructions, for professionals only
Changing the light dimming characteristic
Because incandescent bulbs and LEDs react differently to the dimming function,
it is possible to select the dimming characteristic according to the light system
used. Perform the following steps:
1. Open the technician menu (see Page 39).
2. Select "dl" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired setting using the plus button B and the minus button C.
● "bUL" means the dimming characteristic for incandescent bulbs is acti-
vated (standard)
● "LED" means the dimming characteristic for LEDs is activated
5. Confirm the selection by pressing the On/Off button A.
6. Make other settings or leave the technician menu by pressing the On/Off
button A for about 3 seconds.
7. Then switch the power unit off for about 10 seconds.
Setting the light operating mode
The light for the sauna room can either be dimmed or switched on and off.
Perform the following steps:
1. Open the technician menu (see Page 39).
2. Select "dIL" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired setting using the plus button B and the minus button C.
● "on" means that the light is dimmable (standard)
● "oFF" means that the light is switchable
5. Confirm the selection by pressing the On/Off button A.
6. Make other settings or leave the technician menu by pressing the On/Off
button A for about 3 seconds.
7. Then switch the power unit off for about 10 seconds.
WORLD OF WELLNESS
p. 41/70
EN