Starting Combi Mode (Only Pro D3/Pro D3I); Switching Off Combi Mode (Only Pro D3/Pro D3I) - Sentiotec Pro D Serie Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Instructions for use for the user

10.7. Starting combi mode (only Pro D3/Pro D3i)

1. Select the temperature symbol 5 by pressing the mode button D.
Then briefly press the On/Off button A.
► The sauna heater switches on.
2. Set the desired temperature with the plus button B and the minus button C.
► The display 1 shows the desired temperature for a few seconds.
► Depending on the setting (see: "Temperature/humidity display (actual/
set value)" on page 38) the display 1 then shows the actual value
(standard setting) or the set value.
3. Select the humidity symbol 6 by pressing the mode button D.
Then briefly press the On/Off button A.
► The evaporator switches on.
4. Set the desired humidity with the plus button B and the minus button C.
► The display 1 shows the desired humidity for a few seconds.
► Depending on the setting (see: "Temperature/humidity display (actual/
set value)" on page 38) the display 1 then shows the actual value
(standard setting) or the set value.

10.8. Switching off combi mode (only Pro D3/Pro D3i)

● Select the temperature symbol 5 by pressing the mode button D.
Then briefly press the On/Off button A.
► The sauna heater and the evaporator are switched off.
► The display 1 shows "oFF"
If the sauna control unit is used without a humidity temperature sensor
(FTS2), cyclic mode is activated. If the sauna room temperature is less
than 30 °C, the evaporator is activated continuously for 10 minutes.
This ensures that the water in the tank reaches a basic temperature level.
Cyclic mode then starts.
WORLD OF WELLNESS
p. 51/70
EN

Publicité

Table des Matières
loading

Table des Matières