Setting And Functions; Display And Control Keys; Control Key Functions - Burkert 8022 Mode D'emploi

9.

seTTing anD FuncTiOns

9.1.

Display and control keys

with check mark = active
without check mark = not active
selection, input and confirmation
(see chapter 9.1.1.Control key
Figure 7: Display and control keys
9.1.1.

control key functions

The device is operated using two arrow keys and one ENTER key.
Their function with regards to the operating level is described in the following table.
Operating level
(see chapter
9.3.Operating levels)
Level 1:
Read level
Level 2:
Configuration level
Table 1: Control keys
14
Status display:
K factor
Process Value
Control keys:
Keys for
functions)
Switching over the display value from:
• PV ProcessValue in set flow rate unit
• PV ProcessValue in mA
• PV ProcessValue in Hz (frequency of sensor)
Scroll up (select).
Enter values
Increase numerical value
by one value.
English
LC display
Unit of flow rate
Unit of output value
Upper/Lower limit (High/Low)
4-character display
Scroll down (select).
Change by one position
to the left.
Type 8022
SettingandFunctions
Press and hold for 3 s:
Change to the configuration
level
Confirm parameter, change
between parameters.
Select and deselect
parameter, confirm set values.
Change to Read level when
End is shown