Aiwa XR-M919 Mode D'emploi page 47

Troubleshooting
If your system fails to perform properly, check the following
guide and the relevant sections of the Operating Instructions.
There is no sound
•Are the speakers and AC power cord connected properly?
The system shuts off suddenly
•Possibly a short circuit in the speaker terminals. Disconnect
the AC power cord from the AC power socket and reconnect
the speaker cords correctly.
Erroneous display
•Reset the system. (See "Resetting the system" on this page.)
Poor radio reception
•Check antenna connection. Adjust the antenna to find the
best reception.
•Move the system and antenna away from other electric
appliances and cords.
The tape does not run
•Is the deck in pause?
Poor tape sound
•Check for dirty heads. Clean them if needed.
Cannot record on a tape
•Is the erasure prevention tab of the tape broken off? If so,
cover the tab opening with adhesive tape.
The CD player works poorly
•Is the disc correctly loaded?
•Is the disc dirty?
•Is the lens affected by condensation? If so, wait
approximately one hour and try again.
MD recording is not possible
•Is CDlMD (NORMAL/HIGH) pressed when attempting to
record from a source other than CD?
•Is a prerecorded disc inserted? If so, change to a recordable
one.
•Is the disc protected by the record-protect tab on the disc?
(see page 24)
•Are the Mini Disc Recorder and the Compact Disc Player
connected with the optical cable? If not, digital recording
from a CD onto an MD cannot be made.
Resetting the system
If an unusual condition occurs in the display window or the
cassette deck, reset the system as follows:
1 Press POWER to turn off the power.
If the power cannot be turned off, disconnect the AC power
cord, then plug it in again.
2 Hold down CLEAR on the Stereo Tuner and press POWER.
Everything stored in memory after purchase is cleared.
En
47