Tape Recording - Aiwa XR-M919 Mode D'emploi

Music sensor
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
En
playback can be done easily.
When the X indicator on the display is appearing, press
f to move to the next track or g to move to the
begininng of the current track.
When the C indicator on the display is appearing, press
g to move to the next track, or f to move to the
beginning of the currect track.
The search function may not be able to detect tracks under
the following conditions:
•Blanks of less than 4 seconds between tracks
•Noisy tracks
•Long passage of low-end sound
•Low overall recording levels
To reset the tape counter
Press s in stop mode, and the tape counter on the display is
reset to "0000".
Opening and closing the tape tray will also reset the tape
counter.
Notes on cassettes
•Use of 120-minute or longer tapes is not recommended
since they are extremely thin and easily deformed or
damaged.
•Wind up any slack in the tape with a pencil or similar tool
before use. Slack tape may jam in the mechanism.
18

TAPE RECORDING

REV MODE
SYNC REC
FUNCTION
Basic recording
Use type I (normal) or type II (high/CrO
2
1 Press zOPEN/CLOSE to open the tape tray.
2 Insert the recording tape.
Insert with the exposed side facing forward, and the side
to be recorded on first facing upward. Press zOPEN/
CLOSE to close the tape tray.
3 Turn FUNCTION (or press TAPE/REV MODE on
the remote control) to select the TAPE function.
4 Press REV MODE (TAPE/REV MODE on the
remote control) to select the reverse mode.
To record on one side only, select p.
To record on both sides, select [ or ].
5 Turn FUNCTION to select the source to be
recorded.
(with the optional Stereo Cassette Deck)
zOPEN/
CLOSE
CD EDIT/
REC
CHECK
0-10,+10
SHIFT
MD REC
(ANALOG)
f,g
f,g
6 Prepare the source.
To record CD, load a disc.
) tapes for recording.
To record a radio broadcast, tune in the desired station.
To record from connected external equipment, turn
FUNCTION to select the AUX function and prepare the
equipment.
7 Press REC to start recording.
When recording a CD, CD play starts automatically.
When recording input from connected equipment,
manually start playback of the source.
•Volume or tone adjustment(s) does not affect recording.
To start CD recording more easily
Insert the tape to be recorded, load the disc, and press SYNC
REC. Regardless of the function currently selected, CD play
and tape recording starts simultaneously.
TAPE/
REV MODE
TUNER MONO
CD
w
a
s