Aiwa XR-M919 Mode D'emploi page 26

To start recording with the remote control
After performing steps 1 to 6 on page 25, instead of performing
steps 7 to 9, proceed as follows:
En
1 Press CD to select the CD function.
2 Press REC MODE (DIGITAL) repeatedly to select
the recording mode and speed.
"RecSTEREO": standard length stereo recording mode
at normal speed
"RecSTEREOx2": standard length stereo recording
at double speed
"Rec LP2": two times longer stereo recording at normal
speed
"Rec LP2x2": two times longer stereo recording at
double speed
"Rec LP4": four times longer stereo recording at normal
speed
"Rec LP4x2": four times longer stereo recording at
double speed
3 Press w.
4 Press a to start recording.
To change the display
Press DISPLAY (or hold down SHIFT and press DISPLAY on
the remote control). The display changes as follows:
1 Track number and elapsed playing time of CD
(Example: CD 1Tr 1:23)
2 Remaining playback time of CD
(Example: CD -48:07)
3 Remaining recordable time on MD
(Example: MD -52:33)
4 Track number and elapsed playing time of MD
(Example: MD 10Tr 1:25)
26
When "LONG CD" is displayed
The remaining recordable time on the MD is shorter than the
total playing time of the CD.
Replace the MD with another one. If you press CDlMD
NORMAL or HIGH, recording will be made up to the limit of
the recordable time on the MD.
To record on a previously recorded MD
If there is an unrecorded section left on the MD, the new
recording automatically starts from where the previous
recording finished.
If you want to start recording from the beginning of a previously
recorded MD, erase the previous recording completely (see
"Erasing all the tracks on a disc" on page 41).
If "WaitXXmin" is displayed when trying to record
at double speed
Your desired CD has already been recorded at double speed
starting within the last 74 minutes. Double speed recording
of this CD is disabled by the copy-protect feature (see "Copy-
protect features" on page 29) until the disabled time has
passed.
Notes
•During digital recording at normal or double speed, a
cannot be used.
•Recording from a CD-R/RW to an MD may be prohibited by
the SCMS standard (see "Copy-protect features" on page
29). In this case, recording immediately stops after you
started MD recording. Some very short tracks are added on
an MD, so erase them as described in "Erasing a single
track" on page 40.
•In rare cases, double speed recording of a CD-R/RW disc
may not be made properly depending on the recording
condition of the CD-R/RW disc. In this case, record at normal
speed.
•Another double speed recording of the same CD cannot be
performed during 74 minutes after the preceding double
speed recording has been started.