Md Edit - Aiwa XR-M919 Mode D'emploi

MD EDIT

(with the optional Mini Disc Recorder)
GROUP DIRECT
MD MODE
MD EDIT/REC
FUNCTION
Before editing
While "WRITING" is displayed, do not disconnect the AC
cord or give a strong shock to the system. Otherwise, the edited
contents on a disc will not be able to be played.
Note
A disc cannot be edited:
- when a prerecorded disc is inserted ("PB Disc" is
displayed).
- when the record-protected tab on a loaded disc is moved to
the protected position ("Protected" is displayed).
- during programmed play.
When editing tracks created by the group function
When tracks are edited (moved, combined, divided or erased)
on other equipment which does not support the group function
or using the disc mode of this system, the group function
may not work correctly.
c
f,g
s
a
MD MODE
MD EDIT
ENTER/
SHIFT
ILLUMINATION
VOLUME/
MULTI JOG
Registering the disc and track title
You can register the titles of the discs and tracks.
Personal messages also can be registered.
1 Turn FUNCTION to select the MD function and
insert an MD.
2 To register a disc title: press MD MODE (or hold
down SHIFT and press MD MODE on the remote
control) to display "Disc Title?".
To register a track title: while either in the disc
mode or group mode, select or play the track and
press MD MODE (or hold down SHIFT and press
MD MODE on the remote control) to display "XXTr
Title?" (XX is a track number).
3 Within 8 seconds, press ENTER/ILLUMINATION
(ENTER/ILLUMI).
4 Press MD MODE (hold down SHIFT and press
MD MODE) to select the kind of character.
"A>" : capital letters
"a>": small letters
"0>": numbers and symbols
* "a>" is not displayed with the remote control. Display
"A>" to enter either capital letters or small letters.
5 Enter characters.
ENTER/
Turn VOLUME/MULTI JOG to select the desired character,
ILLUMI
then press g.
GROUP
On the remote control, press the character buttons (see
(DIRECT)
page 34) seveal times to select a desired character, then
s
press g.
When g is pressed, the selected character moves one
column to the left.
6 Repeat steps 4 and 5 to enter all the required
characters (up to 50 characters).
Note that the total number of characters that can be entered
for one disc is approximately 1,600.
7 Press ENTER/ILLUMINATION (ENTER/ILLUMI).
Editing characters while in entry mode
•To change a character during entering
Press f or g repeatedly until the character to be
changed flashes. Then enter the desired character again.
•To delete characters
Press f or g repeatedly until the character to be
deleted flashes. Then press a.
•To insert a space between the characters
Press f or g repeatedly until the part to be entered
as a space flashes. Then press c.
En
33