Aiwa XR-M919 Mode D'emploi page 16

EON Search
The system can leap to a station which has just started
broadcasting your desired PTY.
En
In EON (Enhanced Other Networks information) Search, the
system is in standby mode until the desired PTY begins. As
soon as it begins, the system "leaps to" another station with
the PTY and returns to the previously tuned station when it
ends. EON Search makes the function above possible with the
help of EON which gives the receivers a cross reference to other
stations. You need to preset every available station in advance
since the system searches only the preset stations.
1 Press DEMO/RDS repeatedly until the program
type of the currently tuned station is displayed.
2 Press TUNING UP or DOWN or turn VOLUME/
MULTI JOG to select a program type.
If TUNING UP or DOWN is not pressed within 10 seconds,
the EON search will be cancelled.
3 Press SET.
If SET is not pressed within 10 seconds, the EON search
will be cancelled.
"EON ON" is displayed for 3 seconds and then the system
enters the standby mode while "EON" flashes. When the
system leaps to another station, "EON" flashes rapidly.
To return to the previously tuned station from the
"leaped to" station
Press CLEAR (s). The standby mode for EON Search is also
cancelled.
To cancel the standby mode for EON Search
Press DEMO/RDS repeatedly so that the program type display
appears. Press CLEAR (s) and then press SET (a).
•The standby mode for EON Search will not be cancelled
even if the system is turned off.
16
Note on PTY & EON Search
PTY & EON Search do not function under the
following conditions:
- FM stations are not preset.
- The signals of the station broadcasting the desired PTY are
weak.
- FM RDS stations cannot be received.
Clock-time (CT)
You can automatically set and update the clock on
the hour every hour just by tuning in an RDS station
since RDS stations transmit clock signals.
1 Press DEMO/RDS repeatedly to select "CT ON"
while the system is on and the time is displayed
(see "Setting the clock").
2 Tune in an RDS station.
To deactivate CT function (If the clock is set wrongly
due to an incorrect clock signal)
An RDS signal will update the clock time on the hour every
hour.
Note on RDS features
The RDS features described above may not function correctly
if the RDS transmission data from the station contains too
much interference or the reception signal is too weak.
Adjustments
To switch to monaural FM reception
Hold down SHIFT and press TUNER MONO on the remote
control so that "TUNER MONO" is displayed.
To cancel, press again to display "Auto STEREO".
Tip:
When FM stereo reception is poor, switching to monaural
reduces noise.
To switch the MW tuning interval
The default setting of the MW tuning interval is 9 kHz/step. If
you use this system in an area where the frequency allocation
system is 10 kHz/step, change the tuning interval.
Hold down BAND and press POWER.
Tip:
When the MW tuning interval is changed, all preset stations
are cleared.