Device Status - Assignment Of The Leds; Change Assignment Of The Top Leds (Device Status) - Burkert 8691 Manuel D'utilisation

Type 8691
AS-Interface installation
10.6.2. device status - assignment of the leds
The device status of the control head (transparent cap) is displayed optically by colored high-power LEDs (Top
LEDs).
The following functions are shown as standard
color
green Top LEDs on
yellow Top LEDs on
red LED flashing
alternately with the green or
yellow Top LEDs
Table 11: Assignment of Top LEDs - AS-Interface
10.6.3. change assignment of the Top leds (device status)
Danger!
risk of electric shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
Procedure:
→
The jumpers can be ac cessed by unscrewing the body casing (stainless steel).
→
Using the jumpers, assign the required color to the Top LEDs (see "Figure 31").
Valve connection
Internal
connection
Figure 31: AS-Interface PCB
device status
End position bottom
End position top
no data traffic
or
Teach function error
Jumper for assignment of Top LEDs
Jumper function:
You can set the color assignment of the end posi-
tions with the jumpers.
You can indicate for each color whether it applies
to the Top (upper end position) or Bot (lower end
position).
english
41