ITW Food Equipment Group VULCAN V24 Mode D'installation Et Mode D'emploi page 15

STANDARD OVEN LIGHTING AND SHUTDOWN INSTRUCTIONS
NOTE: Light open top/griddle pilots before lighting oven pilot.
1. Turn thermostat to the "OFF" POSITION.
2. Wait 5 Minutes.
3. After pilot is lit, turn the thermostat to the desired setting.
4. Remove the lover panel. (Fig. 18)
5. Depress the red button on the safety valve and light the pilot
through the observation area. (Fig. 19)
6. Hold down the red button for atleast 30 seconds.
7. When button is released, pilot should remain lit.
8. Replace lower panel.
9. Turn thermostat to desired temperature.
10. If the pilot becomes extinguished repeat the above procedure.
i F . g 1
Nightly Shutdown
Turn oven thermostat OFF.
Complete Shutdown
1. Turn oven thermostat OFF.
2. Turn main gas supply OFF.
RACK ARRANGEMENT - STANDARD OVEN
The standard oven has two rack positions and is supplied with one oven rack. Additional racks may be
obtained through a Vulcan-Hart parts depot.
For best results when baking cakes and pastries, it is recommended that only a single rack position be
utilized. However, proper rack usage and positioning is really determined by the individual cooking
needs of the operator. If you are cooking a large roast, the entire oven cavity may be utilized. Remove
the oven rack completely from the range and place the roasting pan directly on the oven bottom.
8
— 15 —
i F . g 1 9