Installation Codes And Standards - ITW Food Equipment Group VULCAN V24 Mode D'installation Et Mode D'emploi

INSTALLATION CODES AND STANDARDS

Ranges must be installed in accordance with:
In the United States of America:
1. State and local codes.
2. National Fuel Gas Code, ANSI/Z223.1 (latest edition). Copies may be obtained from The American
Gas Association, Inc., 1515 Wilson Blvd., Arlington, VA 22209.
NOTE: In the Commonwealth of Massachusettes,
All gas appliances vented through a ventilation hood or exhaust system equipped with a damper
or with a power means shall comply with 248 CMR.
3. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
4. Vapor Removal From Cooking Equipment
The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1. Local codes.
2. CSA B149.1 Natural Gas and Propane Installation Code.
3. CSA C22.1 Canadian Electric Code.
4. CSA C22.2 Canadian Electric Code.
The above are available from the Canadian Standard Association, 5060 Spectrum Way, Suite 100,
Mississauga, Ontario, Canada L4W 5N6.
ASSEMBLY
Ranges Mounted on Casters
Ranges mounted on casters must use a flexible connector (not
supplied by Vulcan) that complies with the Standard for
Connectors for Movable Gas Appliances, ANSI-Z21.69 • CSA 6.16
and a quick-disconnect device that complies with the
Standard for Quick-Disconnect Devices for Use With Gas
Fuel, ANSI-Z21.41 • CSA 6.9. In
must be provided to limit movement of the appliance without
depending on the connector and the quick-disconnect device
or its associated piping to limit appliance movement. Attach the
restraining device at the rear of the range as shown in Fig. 1.
Remove two screws from the rear of the range and install the
tie-down strap shipped with the casters using these screws
(Fig. 1). Attach the gas line strain relief to the tie-down strap at the rear of the range (Fig. 1).
If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect
this restraint prior to turning the gas supply on and returning the range to its installation position.
Separate instructions for installing casters to the range are included with the casters.
Note: If the range is installed on casters and is moved for any reason, it is recommended that the range
be releveled front to back and side to side.
, NFPA-96 (latest edition). Copies may be obtained from
addition, adequate means
— 5 —
CONNECT GAS LINE
STRAIN
RELIEF HERE
PL-51219
Fig. 1