Spare Parts And Accessories; Factory Fitted Accessories; Accessories Supplied Lose; Transport - Handling And Storage - Hitecsa ADVANCE EQP1X Mode D'emploi

II.2

SPARE PARTS AND ACCESSORIES

IMPORTANT!
Only use original spare parts and accessories.
HITECSA shall not be held liable for damage caused
by tampering or work carried out by
unauthorised personnel or malfunctions caused by
the use of non-original spare parts or accessories.
II.2.1

FACTORY FITTED ACCESSORIES

P2 – Installation with pump with increased static pressure on primary
circuit for model 133.
ASP2 – Installation with increased static pressure on primary circuit
pump and water buffer tank for model 133.
SIL – All of the units are available with the "SIL" kit, which provides a
special soundproof compartment, compressor cover and fan adjustment
device.
RAA – water buffer tank antifreeze electric heater (90 W for models
117÷130, 300 W for models 133) (available for installations ASP1 –
ASP2).
RPB – Coil protection networks.
DSP – Double set point by means of digital consensus (incompatible
with the CS accessory). Handled as a special accessory by our pre-
sales office.
CS – Scrolling set point by means of the 4-20 mA analogue system
(incompatible with the DSP accessory). Handled as a special
accessory by our pre-sales office.
II.2.2 ACCESSORIES SUPPLIED LOOSE
KSA – Anti-vibration supports.
KRPB – Coil protection networks.
KTR – Remote keypad for control at a distance with rear illuminated
LCD display (same functions as the one built into the machine).
KSC – Clock card to display date/time and to regulate the machine with
daily/weekly start/stop time bands, with the possibility to change the set-
points.
KRS485 – RS485 serial interface card to create dialogue networks
between cards (maximum of 200 units at a maximum distance of 1,000)
and building automation, external supervision systems or
supervision systems (supported protocols: proprietary protocol;
®
Modbus RTU).
KFTT10 – FTT10 serial interface card for connection to supervision
®
systems (LonWorks system compliant with Lonmark
with chiller profile).
KISI – CAN bus serial interface (Controller Area Network compatible
with evolved hydronic system for integrated comfort management
®
(protocol supported CanOpen ).
KBE – Ethernet interface for serial communication with other devices
(BACnet IP protocol).
KBM – RS485 interface for serial communication with other devices
(BACnet MS/TP protocol).
KUSB – RS485/USB serial converter for interconnection between
RS485 serial network and supervision systems with serial connection to
PC via USB port (USB cable provided).
Description and fitting instructions are supplied with each
accessory.
II.3

TRANSPORT - HANDLING AND STORAGE

DANGER!
The unit must be transported and handled by
skilled personnel trained to carry out this type of
work.
IMPORTANT!
Be careful to avoid damage by accidental collision.
IOM_EQP1X_117a133_208094_200901_ES-EN-FR-DE-IT
II.3.1
The EQP1X 117÷130 models are supplied:
 in cardboard packaging.
 protected above by a wooden frame;
 fixed to a pallet by 4 screws;
 tied down by two straps;
Each unit is supplied complete with:
 Instructions for use;
 Wiring diagram;
HITECSA
 List of authorised service centres;
 Warranty documents;
 Pump use and maintenance manual.
®
8090-10 protocol
50
SECTION II: INSTALLATION AND MAINTENANCE

PACKING, COMPONENTS

DANGER!
Do not open or tamper with the packaging before
installation. Do not leave the packaging within
reach of children.
ENVIRONMENTAL PROTECTION
Dispose of the packaging materials in compliance
with the national or local legislation in force in your
country.
EQP1X 117÷130