I.7.3 Unit Start-Up; I.7.4 Shutdown; I.7.5 Changing The Operating Mode - Hitecsa ADVANCE EQP1X Mode D'emploi

I.7.3 UNIT START-UP
Hold the ON/OFF key down for 2 seconds in order to switch the unit on.
The message ON will appear on the third line of the display.
!
ALARM
ON
Prg
OFF
ON
OFF
I.7.4 SHUTDOWN
Hold the ON/OFF key down for 2 seconds in order to switch the unit off.
The message OFF BY KEYB will appear on the third line of the display.
!
ALARM
ON
Prg
OFF
ON
OFF
I.7.5 CHANGING THE OPERATING MODE
In order to change the unit operating mode, just access the main screen
and press down the MODE / Enter key for 2 seconds.
In order to make the unit operate in
AUTOMATIC mode.
!
ALARM
MODE
Prg
ON
OFF
IOM_EQP1X_117a133_208094_200901_ES-EN-FR-DE-IT
0.00 C
Inlet Water
Outlet Water 0.00 C
MODE
ON
SELECT
Inlet Water 0.00 C
Outlet Water
0.00 C
MODE
OFF BY KEYB.
SELECT
AUTOMATIC mode, set the
Inlet Water 0.00 C
Outlet Water
0.00 C
MODE
OFF BY KEYB.
AUTOMATIC
In order to make the unit operate in
mode.
MODE
I.7.5.1 Priority management in
In order to manage the priorities in
and proceed as follows:
Press the Prg key for 3 seconds.
Prg
Use the DOWN key to run through the templates until coming to the
Probe Menu screen.
41
SECTION I: USER
SELECT mode, set the SELECT
!
ALARM
Inlet Water 0.00 C
Outlet Water 0.00 C
Prg
OFF BY KEYB.
SELECT
ON
OFF
SELECT mode
SELECT mode, switch the unit off
!
ALARM
> Setpoints menu
Probe menu
Prg
Condensing control
Rem.Auto/Select
ON
OFF
!
ALARM
Setpoints menu
> Probe menu
Prg
Condensing control
Rem.Auto/Select
ON
OFF
MODE
MODE
MODE