Lifting And Handling; Handling Precautions; Storage Conditions - Hitecsa ADVANCE EQP1X Mode D'emploi

II.3.2

LIFTING AND HANDLING

DANGER!
Movement of the unit should be performed with
care, in order to avoid damage to the external
structure and to the internal mechanical and
electrical components.
Also make sure that there are no obstacles or
people blocking the route, to avoid the danger of
collision or crushing. Make sure that there is no
possibility of the lifting-gear overturning.
The unit is supplied on a wooden support structure. This structure
serves to facilitate unit transport using a forklift or a hand truck. Use this
method to transport the unit to the installation position.
On arrival at the final installation site, remove the wooden substructure
(unscrew the 4 screws). Pass the straps through the slots in the base of
the unit, having first checked their suitability (as regards their strength
and state of wear and tear). Take the strain on the slings, checking that
they remain properly attached to the lifting-hook; lift the unit a few
centimetres, then, only after checking the stability of the load, slide the
pallet out, taking care not to trap any parts of the body, in order to
eliminate any possible risk of crushing or any other injury if the load
drops or shifts suddenly. Carefully carry the unit to the installation site.
Lower the unit carefully and fix it into place.
IOM_EQP1X_117a133_208094_200901_ES-EN-FR-DE-IT
SECTION II: INSTALLATION AND MAINTENANCE
II.3.2.1

Handling precautions

DANGER!
The centre of gravity is not at the centre of the unit
and could cause sudden, hazardous movements.
Movement of the unit should be performed with
care, in order to avoid damage to the external
structure and to the internal mechanical and
electrical components. Also make sure that there
are no obstacles or people blocking the route, to
avoid the danger of collision, crushing or the lifting-
gear overturning.
I
ON
Model
EQP1X 117 P1
EQP1X 124 P1
EQP1X 130 P1
II.3.3

STORAGE CONDITIONS

The units cannot be stacked. The temperature limits for storage are
-9°÷45°C.
51
X Y
X Y
mm 540 250
mm 540 250
mm 630 300