Table des Matières
Publicité
1
CARBURETOR
• Fully turn in the accelerator pump adjust-
ing screw 3.
• Check that the link lever 4 has free play
b by pushing lightly on it.
• Gradually turn out the adjusting screw
while moving the link lever until it has no
more free play.
Carburetor installation
1. Install:
• Carburetor joint 1
NOTE:
Install the projection a on the cylinder
between the carburetor joint slots b.
2. Install:
• Carburetor 1
NOTE:
Install the projection a between the carburetor
joint slots.
3. Install:
• Hot starter plunger 1
4. Tighten:
• Screw (air filter joint) 1
• Screw (carburetor joint) 2
4 - 19
ENG
3 Nm (0.3 m · kg, 2.2 ft · lb)
2 Nm (0.2 m · kg, 1.4 ft · lb)
3 Nm (0.3 m · kg, 2.2 ft · lb)
3 Nm (0.3 m · kg, 2.2 ft · lb)
Publicité
Table des Matières
