4.4.6 RELAY (OPTION)
The parameter definition of the limit contacts is completed within this mode. Two limit
values are entered for each relay : 1 -, 1 + and 2 -, 2 +. The user also has the option
to invert the relays.
The following conditions must be observed: 1-
Ensure that security provisions are taken for the relay circuits
(3A max).
1- and 2-
= the low settings for both relays
1+ and 2+ = the high settings for both relays
Contact
Invert no
CLOSED
OPEN
1-
Contact
Invert yes
CLOSED
OPEN
1-
8045
CALIBRATION
1+
Flow
1+
Flow
0......9
ENTER
27
≤
≤
1+, 2-
2+.
Fluid Control Systems