Calibration Menu - Burkert 8045 Mode D'emploi

4.4

CALIBRATION MENU

ENTER
PRESS
The internal Switch2 must be set in the unlocked position to enter parmeters
within this menu. (§ 3.4.1)
The following parameters can be set within this menu:
LANGUAGE
K-FACTOR
CURRENT
PULSE
0......9
RELAY
FILTER
TOTAL
FREQUENC
The following sections explain how to change the parameter values within the
calibration menu above.
8045
CALIBRATION
SIMULTANEOUSLY FOR 5 SECONDS
Selection between English, German,
French, Italian and Spanish.
Selection of engineering units to
UNIT
display flowrate and totalizer.
Input of K-factor according to chart or
Teach-in function in order to determine
the specific K-factor.
Determination of 4-20 mA measuring
range.
Parameter definition of pulse output
(unit and volume).
Parameter definition of relays. This
message only appears if the relay
option has been installed.
Damping selection. There are 10 steps
available and 2 filtering modes.
Totalizer resetting.
Selection of the mains AC frequency
(50 or 60 Hz).
Return to operation mode and storage
END
of new parameters.
21
SECTIONS
4.4.1
4.4.2
4.4.3
4.4.4
4.4.5
4.4.6
4.4.7
4.4.8
4.4.9
Fluid Control Systems