Programming - Trek Ride+ Manuel Du Propriétaire

4.9 Programming

This section explains how you set the odometer units (miles or kilometers), the clock, the wheel
diameter and how you can swap the functionality of the buttons and select the correct language.
To enter programming mode, press buttons 'On/Off' and 'Mode-switch' for two seconds.
Four zeros will appear, with the first zero blinking.
Enter the appropriate code by pressing button '+' for a higher value, '-' for a lower value. Press
button 'On/Off' to select a value and move to the next digit. After entering the correct value for the
fourth digit, press button 'On/Off' to move into the chosen menu. In the programming menu,
buttons '+' and '-' will move to a higher or lower value. Pressing button 'On/Off' will save the entry
and move you to the next step, or back to the regular display.
Codes:
2001
to switch between miles and kilometers.
2004
to set the time.
2009
to swap the function of the buttons from left to right and vice versa.
2 0 1 1
to change the display language (on 'Pro' controller only). Use button to scroll through the
languages.
3 7 7 1
to set the correct wheel diameter.
I
nstruCtIons for
u
se
EN-28