Trek Ride+ Manuel Du Propriétaire page 23

• Mountain mode
The "Mountain Mode" allows for longer uphill riding before the motor shows power reduction due to
so-called "temperature-derating". As "Mountain Mode" limits the maximum motor torque the motor
will stay cooler for a longer period of time. Select this option by going to assistance level 4 and then
press-and-hold the '+' button for 2 seconds. To return to assistance level 4, press the '-' button once.
• Changing the language option of the controller
The RIDE+ Pro controller allows you to change the language that is displayed on the screen.
See the part 'programming' later in this manual to set the correct language.
• Removing and installing the RIDE+ Pro controller
To remove the RIDE+ Pro controller from the bike, press the catch of
the holder and slide the controller off towards the rear. To install the
RIDE+ Pro controller onto the handlebar, align the controller with its
clamp and slide the controller forward until it clicks.
NOTICE. To prevent loss of riding information, please make sure that
the controller is switched Off before it is removed from the bike.
• Unintended removal of controller out of its dock
If the controller is moved off its clamp while the system is active ('On'), the system will no longer
assist, even when the controller is replaced into its clamp. Please select the correct level of
assistance again to reactivate the system.
• Using the RIDE+ Link
Most bikes with the RIDE+ Pro controller are equipped (or can be equipped)
with the RIDE+ Link.
This device is mounted either the right or left side of the handlebar and can
be used to regulate the following functions without moving your hands off
the handlebar:
1. ' , ' button
Switch light On/Off
2. '+' button
Increase assist level (or decrease regeneration level)
3. '-' button
Decrease assist level (or increase regeneration level)
4. Throttle button For Pedelecs: walk assist up to 4 km/h (pedaling not needed)
For fast E-bikes: assist up to +/- 20 km/h (pedaling not needed)
The red throttle button on the RIDE+ Link remote is a convenient help to move the bike without
pedaling (up to 4 km/h) walking next to the E-bike.
WARNING. Beware of unintended use of the throttle button when the system is switched On.
I
nstruCtIons for
u
se
1
2
3
4
EN-20