Start-Up; Removal - Burkert 2300 Manuel D'utilisation

8.4.1 connection of the control medium
→
Connect the control medium to the pilot air port (1)
(3 – 7 bar; instrument air, free of oil, water and dust).
→
Fit the exhaust line or a silencer to the exhaust air port (3) and, if
available, to the exhaust air port (3.1).
If used in an aggressive environment, we recommend
conveying all free pneumatic connections into a neutral
atmosphere with the aid of a pneumatic hose.
Exhaust air port
Pilot air port
Additional exhaust air port only
with pilot-operated control
system for high air output
(actuator size ø 130)
Fig. 23: Pneumatic connection
control air hose:
6/4 mm or 1/4" pilot air hoses can be used.
A pilot air port via G 1/8 thread is available as an option.
28
3
1
3.1
english
Type 2300
Installation
8.5

start-up

After installing the device, run the X.TUNE function. This function
presets the control parameters.
Description – see operating instructions for the control.
8.6

removal

Danger!
risk of injury from discharge of medium and pressure!
It is dangerous to remove a device which is under pressure due to
the sudden release of pressure or discharge of medium.
▶ Before removing a device, switch off the pressure and vent the lines.
procedure:
→
Loosen the pneumatic connection.
→
Remove the device.