Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation Requirements
•
The ice machine top panel can be trimmed with an
aviator snips to allow the line set, water line and
electrical connections to exit the top. Only cut out
what is needed, the back panel recess sheet metal
must support the top panel.
•
The ice machine and bin must be level.
•
Vent the ice machine and bin drains separately.
•
Bin drain termination must have an air gap.
•
The water inlet and electrical connection must
contain a service loop to allow future access.
•
The drain line must contain a union or other suitable
means of disconnection at the ice machine.
•
The ice machine and bin must be sanitized after
installation.
•
Routine adjustments and maintenance procedures
outlined in this manual are not covered by the
warranty.
6
Water Supply and Drains
POTABLE WATER REQUIREMENTS
Local water conditions may require treatment of the
water to inhibit scale formation, filter sediment, and
remove chlorine odor and taste.
Follow these guidelines to install water inlet lines:
•
Plumbing must conform to local codes.
•
Do not connect the ice machine to a hot water
supply. Be sure all hot water restrictors installed for
other equipment are working. (Check valves on sink
faucets, dishwashers, etc.)
•
If water pressure exceeds the maximum
recommended pressure of 80 psig (552 kPa), obtain
a water pressure regulator from your Manitowoc
distributor.
•
Install a water shut-off valve and union for potable
water and water cooled condenser lines.
•
Insulate water inlet lines to prevent condensation.
!
Connect to a potable water supply only.
DRAIN CONNECTIONS
•
Drain lines must have a 1.5 inch drop per 5 feet of
run (2.5 cm per meter), and must not create traps.
•
The floor drain must be large enough to
accommodate drainage from all drains.
•
Run separate bin and ice machine drain lines.
Insulate them to prevent condensation.
•
Vent the bin and ice machine drain to the
atmosphere. The ice machine drain requires an 18"
vent. Do not vent the condenser drain on water-
cooled models.
•
Drains must have a union or other suitable means to
allow in place disconnection from the ice machine
when servicing is required.
•
Base drain - Use 1/2" CPVC tubing and silicone
sealant to connect to this optional drain.
•
S3000C requires base drain connection (1" FPT).
Section 2
Warning
Part Number 000006505 12/10
Publicité
Chapitres
Table des Matières
