Sealing Bin Interior; Drain Requirements; Plumbing Connections; Affixing Operating Labels - Manitowoc FC1350 Manuel D'installation, D'utilisation Et D'entretien

Section 2

Sealing Bin Interior

! Caution
The joint between base and bin sections must be
sealed with silastic to prevent leakage and/or ice
contamination and potential voiding of warranty. One
or more shutter doors may need to be removed to
seal bin.
USE SEALANT PROVIDED TO SEAL
ENTIRE PERIMETER OF SEAM WHERE
BASE AND BIN SECTION JOIN.
1. Support shutter door(s) with one hand and remove
thumbscrews from side of shutter door(s) at
underside of base.
2. Pivot door(s) downward to remove.
3. Gain access through this opening and seal entire
perimeter of seam between bin and base with
provided sealant or equivalent.
4. After sealant has set but before shutter door(s) have
been reinstalled, clean inside of bin following
instructions in this manual.
5. Reinstall shutter door(s).
EXTERIOR
Cross Section of Ice Transfer System
Sections Joined
Part Number 000006529 10/09
BIN
INTERIOR
SECTION
BASE
COMPLETELY
SECTION
SEAL GASKET

Drain Requirements

• Bin drain termination must have an air gap.
• Drain lines must have a 1.5 inch drop per 5 feet of
run (2.5 cm per meter), and must not create traps.
• The floor drain must be large enough to
accommodate drainage from all drains.
• Run separate bin and ice machine drain lines and
insulate to prevent condensation.

Plumbing Connections

NOTE: It is recommended that a full width grated floor
drain be installed in front of bin.
1. Units are shipped for a right side exiting drain. To
drain to left, switch positions of screws in trough
brackets from lower hole to upper hole on left
bracket and upper hole to lower hole on right
bracket.
2. Remove plug from left side of drain trough and insert
in right side.
3. Connect drain line to 1-1/4" PVC slip fit drain fitting.
4. Make final connections to ice machine.

Affixing Operating Labels

Operating labels taped to base front educate staff to
shutter door operation. If desired, these labels can be
affixed permanently by peeling off back paper and
affixing in locations desired.
NOTE: Adhesive backing is extremely strong and labels
cannot be easily removed once installed.
Installation Instructions
5