Installation Instructions; Location Of Ice Machine; Ice Machine Heat Of Rejection; Leveling The Ice Machine - Manitowoc UnderCounter Q130 Serie Mode D'emploi

Location of Ice Machine

The location selected for the ice machine must meet the
following criteria. If any of these criteria are not met,
select another location.
• The location must be indoors.
• The location must be free of airborne and other
contaminants.
• The air temperature must be at least 40°F (4°C), but
must not exceed 110°F (43°C).
• The location must not be near heat-generating
equipment or in direct sunlight.
• The location must be capable of supporting the
weight of the ice machine and a full bin of ice.
• The location must allow enough clearance for water,
drain and electrical connections in the rear of the ice
machine.
• The location must not obstruct airflow through or
around the ice machine (condenser airflow is in and
out the front). Refer to the chart below for clearance
requirements.
Self-Contained
Air-Cooled
Top/Sides 5" (127 mm)*
Back 5" (127 mm)*
NOTE: The ice machine may be built into a cabinet.
There is no minimum clearance requirement for the top
or left and right sides of the ice machine. The listed
values are recommended for efficient operation and
servicing only.
! Caution
The ice machine must be protected if it will be
subjected to temperatures below 32°F (0°C).
Failure caused by
temperatures is not covered by the warranty. See
"Removal from Service/Winterization" Section 4.
Part Number 040002380 9/12
Section 2

Installation Instructions

Self-Contained
Water-Cooled
5" (127 mm)*
5" (127 mm)*
exposure to freezing

Ice Machine Heat of Rejection

Series
Ice Machine Air Conditioning**
Q130
Q170
Q210
Q270
* B.T.U./Hour
** Because the heat of rejection varies during the ice making cycle, the
figure shown is an average.
Ice machines, like other refrigeration equipment, reject
heat through the condenser. It is helpful to know the
amount of heat rejected by the ice machine when sizing
air conditioning equipment where self-contained air-
cooled ice machines are installed.

Leveling the Ice Machine

1. Screw the leveling legs onto the bottom of the ice
machine.
2. Screw the foot of each leg in as far as possible.
! Caution
The legs must be screwed in tightly to prevent
them from bending.
3. Move the ice machine into its final position.
!
Do not obstruct ice machine vents or openings.
4. Level the ice machine to assure that the siphon
system functions correctly. Use a level on top of the
ice machine. Turn each foot as necessary to level
the ice machine from front to back and side to side.
NOTE: An optional 2 ½" caster assembly is available for
use in place of the legs on the Q130, Q170, Q210 and
Q270. Installation instructions are supplied with the
casters.
Heat of Rejection*
Peak
2400 2900
2200 2600
2400 3400
3800 6000
Warning
7