Error Message - SICE S 78 TOUCH Manuel D'instructions

- Perform a third spin. This last calibration phase
consists of three consecutive spins executed
automatically.
If the calibration has been successful, a permission
acoustic signal goes off at the end of the spin;
otherwise, the E 2 message is temporarily displayed.
Notes:
- Once the procedure is finished, remove the cali-
bration weight.
- Press the key to interrupt the calibration procedure
at any time.
- This calibration is valid for any kind of wheel.
6.4. Service
This programme displays some data that are used to
test machine operation and to detect the malfunc-
tioning of some devices. Since these data are not
useful for the operator, it is recommended that only
technical support technicians consult them.
6.5. C emergency system release (wheel
clamping device)
This programme allows, in case of emergency, the
device C to be opened when it is NOT possible to
release the wheel using the control pedal C (L,
Fig.10).
In order to operate the C system release press the
button; the machine will automatically
make several attempts to open the device.
6.6. balancing environment
This function makes it possible to select the work-
ing environment required based on the type of
wheel to be balanced:
- AUTO for vehicle wheels with a central hole
- MOTO for motorcycle wheels
- FLANGE for vehicle wheels without a central hole
In the FLANGE and MOTO environment, the auto-
matic clamping system pedal is disabled as the
wheel is centred using the respective accessories.
Using the wheel balancer in FLANGE mode remains
the same as the AUTO environment, in the MOTO
environment the methods change as described in
the "Motorcycle wheel balancing" section.
S78 Touch - Operator's manual
ERROR MESSAGES
The machine can recognise a certain number of mal-
function conditions and signals them by displaying
the relevant messages.
– A – Notice messages
A 3
wheel not suitable for performing the sensitivity
calibration, use a wheel of average dimensions
(typically 5.5"X14") or larger but with a weight that
does not exceed 40 kg.
A 7
The machine is temporarily not enabled to select the
programme requested. Perform a spin, then repeat
the request.
A 25
Programme not available.
A 31
Optimisation procedure (OPT) already launched by
another user.
A 51
Spin with automatic wheel clamping system open
or incorrect wheel clamping. Repeat the locking
operation.
A 52
Hub mounting/demounting procedure started auto-
matic wheel clamping system. The procedure stops
automatically after 30 seconds. Press the Stop button
to interrupt the procedure.
A 60
Incorrect rim spoke storage procedure.
Carefully follow the instructions on the screen or
those in the Hidden weight section.
A 61
Incorrect automatic width measurement or spin
performed without a wheel. Repeat the spin with
automatic dimension acquisition and with a wheel
fixed to the machine. If the problem persists, enter
the correct rim width value manually.
A 63
Incorrectly measured wheel dimensions. Repeat the
spin. If the error persists, set the dimensions manually.
A 64
Incorrect plane acquisition point setting. Repeat
manual positioning of planes.
A 65
Wheel dimensions error. Repeat the spin. If the error
persists, set the dimensions manually.
A 66
Obstacle detected or wheel diameter less than 10"
during internal measuring sensor movement. Repeat
the spin or insert the dimensions manually.
71