SICE S 78 TOUCH Manuel D'instructions page 53

or
vehicle wheels;
press the button again to deactivate the Weight
Reduction suite.
Wheel balancing is performed using the desired
balancing programme. At the end of the spin,
if wheel balancing is considered satisfactory,
the position indicators will display the icons
and two indicators for indicat-
ing the residual rotation torque unbalance level
(left indicator) and static rotation torque level
(right indicator).
2.
selects the required operator:
- This button can be used to change operator
quickly.
- 3 operators can be selected (1, 2 or 3) and named
(see the "Customisation" section).
- When a new operator is selected, the machine
resets the parameters that were active at the last
recall.
The stored parameters are:
- Balancing mode; Dynamic, ALU, etc...
- Wheel dimensions.
- Last phase of OPT.
- General machine settings: grams/ounces, sensitiv-
ity x5/x1, etc...
3.
enables/disables the Smart TS programme
(Smart Tyre Set):
- Selecting the following button defines the wheel
to be analysed:
- selects the front left wheel;
- selects the front right wheel;
- selects the rear right wheel;
S78 Touch - Operator's manual
optimised mode for slow
- selects the rear left wheel;
pressing the button
able the Smart TS programme
Once the data acquisition procedure is complete,
the programme suggests the optimal position of
the wheels on the vehicle.
For more detailed information refer to paragraph
3.2 of the "Wheel Diagnosis Programme" suite.
4.
Enables/disables the unbalance display mode
(gx1 or gx5).
- Select this button to display the unbalance mass
in grams:
of an ounce if the unit of measurement has been
set to ounces;
or
1/4 of an ounce if the unit of measurement has
been set to ounces.
This function is not enabled in the ALU1 and ALU2
programmes (see the "Shift Planes programme"
section).
5.
print menu:
- Select this button to access the print menu for
the programme that is running.
The following is possible in the menu:
- Fill out the empty fields in the report by pressing
the text Entry button
- Start the print process with the Print button
.
again to dis-
to the nearest gram or 1/10
to the nearest 5 grams or
.
53