Electrical Hook-Up; Safety Regulations - SICE S 78 TOUCH Manuel D'instructions

ELECTRICAL HOOK-UP

The wheel balancer is set up by the manufacturer to
operate with the power supply available in the place
of installation. The setup data for each machine are
given on the machine data plate and on a special
label attached to the power supply connection cable.
WARNING
Any operations for hooking up to the workshop
electrical board must be carried out only by
qualified technicians in compliance with the
regulations in force, under the responsibility and
at the charge of the customer.
The electrical hook-up must be performed accord-
ing to:
• Absorbed power specifications indicated on the
machine data plate.
• The distance between the machine and the electric
hook-up point, so that voltage drops under full
load do not exceed 4% (10% when starting up) of
the rated voltage specified on the data plate.
- The user must:
• Connect the machine to a dedicated electrical
power socket equipped with its own differential
circuit breaker with a sensitivity ‡ 30mA.
• Power line fuses in accordance with specifications
in the main wiring diagram of this manual.
• Provide the workshop electric installation with an
efficient grounding circuit.
- To prevent unauthorised use of the machine, always
disconnect the power supply plug when the machine
is not used (switched off) for extended periods of
time.
- If the machine is connected directly to the power
supply by means of the main electrical panel
and without the use of a plug, a key-operated or
padlockable switch must be installed to restrict
machine use exclusively to qualified personnel.
WARNING
A good grounding connection is essential for correct
operation of the machine. NEVER connect the machine
ground wire to a gas pipe, water pipe, telephone
cable or any other unsuitable object.
46

SAFETY REGULATIONS

WARNING
Non-compliance with the instructions and danger
warnings can cause serious injuries to the operator
or other persons.
Do not operate the machine until you have read
and understood all the danger/warning notices
in this manual.
In order to operate the machine correctly, it is
necessary to be a qualified and authorised operator,
able to be trained and to know the safety regula-
tions. Operators are expressly forbidden from using
the machine under the influence of alcohol or drugs
capable of affecting physical and mental capacity.
The following conditions are essential:
- Read and understand the information and instruc-
tions described in this manual.
- Have a thorough knowledge of the features and
characteristics of the machine.
- Keep unauthorised persons well clear of the working
area.
- Make sure that the machine has been installed in
compliance with all relevant standards and regula-
tions in force.
- Make sure that all machine operators are suitably
trained, that they are capable of using the machine
correctly and safely and that they are adequately
supervised during work.
- Do not touch power lines or the inside of electric
motors or any other electrical equipment before
making sure that they have been powered off.
-Read this booklet carefully and learn how to use
the machine correctly and safely.
-Always keep this user manual in a place where it can
be readily consulted and do not fail to refer to it.
WARNING
Do not remove or deface the DANGER, WARNING,
CAUTION or INSTRUCTION decals. Replace any
missing or illegible decals. If one or more decals
have been detached or damaged, replacements
can be obtained from your nearest authorised
dealer.
- When using and carrying out maintenance on the
machine, observe the unified industrial accident
prevention regulations for high voltage industrial
equipment and rotating machinery.
- Any unauthorised alterations made to the machine
automatically release the manufacturer from any
S78 Touch - Operator's manual